Whirlpool 4317332, Техническое образование

Страница: 20 / 28

2-8
REMOVING THE CONTROL BOARD
NOTE: Sharp edges may be present.
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
WARNING
1. Disconnect the electrical power to the
hood.
2. Remove the three filters from the hood.
3. Remove the two screws from the control
assembly and pull the assembly around
through the filter section to the front.
7. Remove the housing screw from the con-
trol assembly.
Control Assembly
Screw
Screw
4. Pull the two pivot pins out of the ends of
the control assembly.
5. Remove the two screws from the cable
clamp and remove the clamp.
Cable Clamp & 2 Screws
Pivot Pins
6. Slide the control housing out of the plastic
frame and remove the plastic pin, spring,
and housing from the frame.
Frame Housing
Spring & Pin
8. Separate the two sections by rotating the
slide switch section away from the hous-
ing and unsnapping the two tabs from their
slots.
Housing Screw
Tab
Tab
Slide Switch Section