SURFACE
MOUNT
Fig. 3
Loud siren noise can cause
hearing loss.
Minimize exposure.
Close windows when using
BOTTOM
VIEW
3"
1.25"
3"
1.75"
3.5"
.437" THRU
(4) PL'CS
1" WIRE
EXIT HOLE
11.84"
DEEP
10.69"
HIGH
15.09
WIDE"
SIDE VIEW
Reach in through
front of siren and
cut wire as close
to siren driver as
possible.
WIRE EXIT
ROUTE
Turn inner horn to adjust
so the word "DOWN" on
the siren driver, is on the
bottom.
Fig. 4
MOUNTING
BASE
10"
5"
7"
3.5"
ù.375
(4) PL'CS
7.75"
3.875"
4.75"
2.375"
9.912"
4.956"
6.92"
3.46"
CUT-OUT
AND REMOVE
THIS AREA
CUT-OUT
AND REMOVE
THIS AREA
CUT-OUT
AND REMOVE
THIS AREA
Fig. 1
GASKET / SEAL
BULKHEAD
MOUNT
(SIDE VIEW)
Extra
Reinforcement
(Optional)
Fig. 2
10.93"
9.970"
MOUNTING SURFACE
7.59"
Bulkhead Mount:
1.
Mark the measurements from Fig. 1 onto the mounting area using a scribe or other suitable tool.
2.
D
rill the 4 mounting holes using an appropriately sized drill, then cut the mounting area out.
3.
Slide the siren into the mounting hole from the front of the vehicle, while sliding the 4 mounting boses into the 4 mounting holes. Make sure
that the rubber gasket is properly seated between the siren and mounting surface (Item “C”, on Pg. 1 & Fig. 2 on pg. 2).
4.
Secure the siren to the vehicle with the 4 supplied washers and bolts, then run the wires to power, and hookup.
Surface Mount:
1.
Using the mounting base as a template, mark off the four mounting holes and wire access hole onto the mounting area, using a scribe or
other suitable tool.
2.
Drill the four mounting holes and wire access hole.
3.
Now attach the siren to the vehicle as shown, using the supplied Hex head bolts and lock washers. (Fig. 4)
4.
Run the wires to power, and hookup.
