Page 2
Specifications:
Input Voltage
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12.8VDC +/-20%
Reverse Polarity Protection
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Up to 60%
Over Voltage Protection
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Up to 60V
Installation and Wiring:
IMPORTANT! This product was designed as part of the WeCanX™
System. It can not be used as a stand alone module.
Caution: Mounting will require drilling. It is absolutely necessary to
make sure that no other vehicle components could be damaged in
the process. Check both sides of the mounting surface before
starting. If damage is likely, select a different mounting location.
Mounting:
1.
Locate a suitable mounting location. A dry, cool compartment is a
good choice.
2.
Position the unit on the proposed mounting location. Using an awl or
similar tool, scribe the mounting surface where the mounting holes
are to be drilled. Make sure that this mounting area allows sufficient
ventilation for the unit.
3.
Remove the unit and using a drill bit sized for a 6 X 3/4” Phillips Pan
Head sheet metal screw, drill a hole in each of the areas scribed in
step 2.
4.
Return the unit to its mounting location. Using the supplied sheet
metal screws secure the unit onto the mounting surface.
5.
Wire as shown
and Install a 15 amp in line fuse (Customer supplied)
on the RED power wire.
Operation:
•
TA module is a ground switched output module designed to run up to
an 8 lamp TrafficAdvisor Lightbar.
•
Module features a 3 position CAN connector which supports the Wecan X command set.
•
A power/ground connector which should be externally fused with a 15 amp slow burn inline fuse on the power side.
•
The TrafficAdvisor module is configurable over CAN through any Cencom Core™ Main Box after adding it as a device in the command
software.
•
Each ground switched output can supply up to 1 amp to either a halogen or LED TrafficAdvisor Lightbar.
WARNING! All customer supplied wires that connect to the positive terminal of the battery must be sized to supply at least 125% of the
maximum operating current and FUSED at the battery to carry that load. DO NOT USE CIRCUIT BREAKERS WITH THIS PRODUCT!
5
10
4
9
3
8
1
1
2
7
1
6
2
GR
Y
N/C
GRN
(+)
Battery
(-)
Ground Switched TrafficAdvisor
WeCanX™ TRAFFIC ADVISOR MODULE
1 2
GR
Y
N/C
GRN
1 2 3
3
2 3
Lamp 7 GND
Lamp 8 GND
10 9
7
8
6 5 4 3 2 1
Lamp 1 GND
Lamp 2 GND
Lamp 3 GND
Lamp 4 GND
Lamp 5 GND
Lamp 6 GND
Battery (+) POS
Battery (+) POS
Fuse @
15 AMPS
RED
BLK
T
o
W
eCanX port
of Control System
