Page 2
IMPORTANT! The lightbar should be a minimum of 16” from any radio antennas!
Permanent Mounting:
1.
Locate the mounting foot and mounting plate included with your lightbar. If not already
present, install the plate onto the mounting foot. When properly positioned, this plate is
centered from side to side on the mounting foot.
2.
Flip the lightbar upside-down to expose the bottom of the extrusion and place the
mounting foot onto the extrusion.
3.
Rotate the mounting foot 90° counter-clockwise. Make sure that the edges of the
mounting foot swing into position under the extrusion mounting lip.
4.
Repeat this procedure for the remaining mounting foot and return the lightbar to its right
side-up position.
5.
Position the lightbar onto the vehicle roof in the desired mounting location. One often
selected location is directly above the B-pillars. This area is the strongest part of the
roof. Refer to your lightbar manual for your lightbars cable exit location, to be sure that
the lightbar is facing the proper direction.
6.
Adjust the two mounting feet outwards so that they are as close to the edge of the roof
as possible. Make sure that both mounting feet are in full contact with the roof. Be sure
that there is no less than 1/2” clearance between the roof and the lightbar at their
closest point. When the mounting feet are in their proper position, lightly tighten the mounting foot allen head set
screws.
7.
Turn the lightbar upside down and tighten all of the set screws from step 6 (2 or 4 per side) to 14-16 In. Lbs..
8.
Note that on the adjustable foot, use the hole in the pad as a guide to drill the two holes into the mounting foot at the
locations shown.
9.
Place the lightbar in its final mounting position on the vehicle, mark the mounting hole locations off onto the mounting
surface, remove the lightbar and drill the mounting holes.
10. Place the lightbar back onto the vehicle lined up with the mounting holes and secure the mounting feet to the vehicle
using the supplied hardware.
Insert foot into extrusion
with locking plate
attached.
Twist foot into
position
ANCHOR
PLATE
loosely secure foot and locking plate.
Cable exit
C a b l e A c c e s s H o l e
Drill the cable access hole in the
appropriate area for your lightbar.
FRONT
M
ount
i
ng
Pad
W
asher
Nut
B
o
l
t
Lock
i
ng
P
l
ate
T
o
rqu
e
S
et
S
c
r
e
w
s
to
14-16 In. L
bs
. !
