Page 2
Mounting:
1. Remove the two frame bolts indicated and install the
speaker bracket using these two bolts (Fig. 1).
2. With the speaker bracket installed, Mount the speaker to
the bracket (Fig. 2).
3. Extend the WHITE (positive) and BLACK (negative) wires
to your amplifier. Refer to the amplifiers instructions for
connections.
IMPORTANT: It is the responsibility of the installation technician
to make sure that the installation and operation of this product
will not interfere with or compromise the operation or efficiency
of any vehicle equipment!
IMPORTANT! Before returning the vehicle to active service,
visually confirm the proper operation of this product, as well as
all vehicle components/equipment
SA315 / Rear View
wire
exit &
drain
hole
A
B
A
A
IMPORTANT:
For drainage purposes, the speaker must be oriented so that
the wire passage hole is in the “6 o’clock” position (closest to the road).
This is the drain hole for the siren. Improper mounting will result in
premature driver failure and void the product warranty.
The SA315 mounting kit comes with three 1/4-20 X 1-1/2 mounting bolts.
The longer bolts are necessary to go
through the mounting bracket, siren
housing and into the siren driver.
The long bolts (“A”) are used in
3 of the 4 mounting holes and
secure the siren driver to the
speaker housing.
Your speaker is shipped with
two 1/4-20 X 1-1/4 bolts
installed. A short bolt (“B”)
be used in the hole that
doesn't go through the bracket
so that it will properly secure
driver to housing.
must
If you need to remove all 4 bolts at
the same time be sure to hold the
driver securely in place.
Mounting the SA315:
1/4" SPLIT
LOCKWASHER
(QTY 3)
1/4" FLAT WASHER
(QTY 3)
1/4 - 20 X 1-1/2"
HEX HD SCREW
(QTY 3)
1/4" SPLIT LOCKWASHER
1/4 - 20 X 1-1/4" HEX HD SCREW
Fig. 2
