Page 2
3/8 - 16 X 2-1/2 Hex Hd Cap Screw
Fig. 3
1/4 Split Lock Washer
SA315
MOUNTING
BRACKET
1/4 - 20 X 1-1/4 Hex Head Bolt
3/8" Flat
Washer
3/8" Split
Lock Washer
3/8" Elastic
Stop Nut
3/8" Flat
Washer
BACK OF BUMPER
1/4 - 20 X 1-1/2
Hex Hd Screw
1/4 Split Lock
Washer
1/4 Flat
Washer
Installation 2013 Ford Fusion:
1.
Remove the front fascia of the vehicle following manufacturers
instructions.
2.
Remove the plastic air dam from the bumper (Fig. 1).
3.
Place the speaker mounting bracket onto mounting location on the
bottom of bumper (Fig. 2).
4.
With the edge of
the siren speaker
mounting bracket
3/4 inches away
from the bumper
bracket (Fig. 2)
mark the location
of
the
speaker
bracket mounting
holes
onto
the
surface
of
the
bumper.
5.
Remove
the
bracket and drill
the mounting holes.
6.
Secure the SA315 to the siren speaker bracket (Fig. 3).
IMPORTANT: The SA315 siren speaker is shipped with two
1/4-20 X 1-1/4" Hex Head Bolts which hold the speaker together.
Replace the bolt toward the top of the speaker with a longer 1/4 - 20 X
1-1/2 Hex Head Bolt (Supplied). One of the shorter bolts must be
used in the bottom
hole that does not go
through the bracket
so it will properly
secure the driver to
the housing. If you
need to remove all 4
bolts at once, make
sure to hold the
driver securely in
place.
IMPORTANT:
For
drainage purposes,
the speaker must be
oriented so that the
wire passage hole is
in the “6 o’clock”
position (closest to
the road). This hole also serves as the drain hole for the siren.
Improper mounting will result in premature driver failure and void the
product warranty.
7.
Secure the speaker bracket (with siren speaker) to the vehicle using
the supplied hardware (Fig. 3).
8.
Extend the speaker wires to your power source then replace the air
dam removed in step 2. You will need to trim some of the air dam to
fit it back in with the speaker installed (Fig. 4).
9.
With the air dam reinstalled, reinstall the vehicles front fascia
removed in step 1 and the installation is finished.
IMPORTANT: It is the responsibility of the installation technician to
make sure that the installation and operation of this product will not
interfere with or compromise the operation or efficiency of any
vehicle equipment! Before returning the vehicle to active service,
visually confirm the proper operation of this product, as well as all
vehicle components/equipment.
