Page 2
Installation:
The speaker bracket mounts behind
the front bumper, where the plastic
filler panel for the driving light is
located (Fig. 1). If a filler panel or a
driving light is present, it must be
removed before installing the
speaker.
1.
Remove the hardware holding in
the plastic filler panel and remove
the panel.
2.
NOTE: Figure 2 shows the
bumper with the plastic filler
panel installed to show the
location of the mounting holes.
Figure 3 shows the bumper
with the plastic filler panel
removed.
There is a grommet
plug in the frame (Fig. 2 “A”).
Remove this grommet plug. This
oblong hole will be one of the
speaker bracket mounting holes.
3.
There are 2 more holes in the frame, toward the outside of the vehicle.
The outer (larger) hole (D) will be the other mounting hole for the
bracket (Fig. 3). This hole is located under a brace attached to the
frame so the mounting bolt will have to be fed up from the bottom.
4.
Secure the siren speaker to the speaker bracket (See information on mounting
the speaker to the bracket above).
5.
Mount the speaker bracket to the vehicle (Fig. 4). Feed the mounting bolt
located toward the outside of the vehicle, up from the bottom because there is a
brace nearby making it difficult to install the bolt from the top (Fig. 5).
6.
Tighten all mounting hardware firmly and installation is complete.
7.
Extend the WHITE (positive) and BLACK (negative) speaker wires to your siren
amplifier and connect as shown in the amplifiers instructions. Test the siren to
confirm proper operation.
It is the responsibility of the installation technician to make sure that the
installation and operation of this product will not interfere with or compromise
the operation or efficiency of any vehicle equipment! Before returning the
vehicle to active service, visually confirm the proper operation of this product,
as well as all vehicle components/equipment.
SA315 / Rear View
wire
exit &
drain
hole
A
A
A
A
IMPORTANT: For drainage purposes, the speaker must be oriented so
that the wire passage/drain hole is in the “6 o’clock” position (closest
to the road). Improper mounting will result in premature driver failure
and void the product warranty.
IMPORTANT:
The SA315 mounting kit comes with
3 long screws (1/4-20 X 1-1/2” Hex Head). The
longer screws are necessary to go through the
mounting bracket, siren housing and into the
siren driver. They will replace
3 of the 4 shorter screws
(“A”)
now secure
the driver to the speaker
housing.
short screw
be used in the hole
that
go
through the bracket
to properly secure the
driver to the housing.
If you need to move the
location of any of the short
bolts try not to remove all
of them at once
.
If you do need to remove all 4 bolts at once
be sure to hold the driver securely in place.
must
does not
since
there will be nothing to
hold the siren driver to the speaker housing
which
Your speaker
is shipped with 1 or
more of the short
screws installed.
A
Mounting the speaker to the bracket:
1/4" SPLIT LOCKWASHER
1/4 - 20 X 1-1/4"
HEX HEAD SCREW
1/4" FLAT
WASHER
1/4 - 20 X 1-1/2"
HEX HEAD
SCREW
1/4" SPLIT
LOCKWASHER
