Page 2
5/16-18 1/2"
DIA. HEX NUT
1/4 LONG X 1/2" OUTR.
DIA. 1/4" CLEARANCE
Fig. 4
5/16-18 X 1-1/4"
HEX HEAD BOLT
WIDEN THESE HOLES
FOR THE 5/16 BOLTS
5/16" SPLIT
LOCKWASHER
USE EXISTING BOLT
FROM VEHICLE HERE
Fig. 3
Viewed from bottom
Viewed from bottom
14 X 1"
PPHSMS
LARGE
SPACERS
SMALL
SPACER
1/4" INTERNAL
TOOTH LOCK
WASHER
MOUNTNG
SURF
ACE
wire passage
& drain hole
MOUTING
SURF
ACE
.325" LONG X .625"
OUTER DIAMETER
Mounting
l o c a t i o n
Viewed from bottom
5/16-18 X 1-1/4"
HEX HEAD BOLT
EXISTING BOLT
5/16-18 1/2"
DIA. HEX NUT
5/16 SPLIT
LOCK WASHER
Fig. 2
Fig. 1
Installation:
NOTE: Figure 1 shows the mounting location of the speaker
bracket with the front of the vehicle removed for visual reference.
You do not need to remove any parts from the vehicle. You will
only need to lower the front gravel shield to make this
installation.
1.
To access the speaker bracket mounting area, remove the clips
holding the front bottom gravel shield and lower the front of the
shield (refer to the vehicle service manual for the recommended
procedure).
NOTE: Do not mount this bracket on the passenger-side of the
vehicle.
2.
With the gravel shield lowered, locate the mounting area (Fig. 1).
The “tab” that protrudes from the side of the bracket will be
secured to the vehicle using an existing bolt (Fig. 3). The top of
the bracket will mount to two existing holes in a metal support on
the vehicle.
IMPORTANT NOTE FOR 2007 MODELS ONLY: On
2007 models these holes must be enlarged to accomodate
the 5/16 bolts.
Before installing, position the bracket in its
mounting area and locate the three mounting holes you will use.
3.
Secure the speaker to the bracket using the supplied hardware
(Fig. 2).
IMPORTANT! For drainage purposes, the speaker must be
oriented so that the wire passage/drain hole is in the “6 o’clock”
position (closest to the road). Improper mounting will result in
premature driver failure and void the product warranty.
4.
Remove the existing bolt that will be used to secure the “tab” on
the bracket to the vehicle. Secure the upper part of the bracket to
the vehicle using the two existing holes with the hardware shown.
The backside of the mounting holes can be accessed allowing the
nuts to be held in place while installing the bolts and spacers.
Tighten the mounting hardware firmly.
5.
Secure the side of the siren bracket to the vehicle using the bolt
removed in step 4 and the small spacer provided.
6.
Extend the WHITE (positive) and BLACK (negative) speaker
wires to your siren amplifier and connect as shown in the
amplifiers instructions. Test siren to confirm proper operation.
IMPORTANT! Before you
return this vehicle to active
service, visually confirm the
proper operation of this
product, and all vehicle
components/equipment.
CAUTION
Loud siren noise can cause
hearing damage and/or loss.
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Wear
Protection!
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
