Page 2
IMPORTANT:
For drainage purposes, the speaker must be oriented so that the wire passage hole
is in the “6 o’clock” position (closest to the road). This is also the drain hole for the siren. Improper
mounting will result in premature driver failure and void the product warranty.
screws are
into the siren driver. (
You will replace 1 of the 2 short screws that secure the siren
The SA315 mounting kit comes with 3 long screws. The long
necessary to go through the
mounting bracket, siren housing and
driver to the speaker housing as it is shipped.
A short screw
be used in the hole that
go through the bracket so it will properly secure the
driver to the housing. If you need to remove all 4 screws at once be sure to hold the driver securely in place.
1/4-20 X 1-1/4” Phillips Flat Head Machine Screw)
must
does not
Mounting the speaker to the bracket:
1/4 - 20 X 1-1/4"
HEX HEAD BOLT (1)
1/4 - 20 X 1-1/4"
PFHMS(3)
1/4" SPLIT
LOCKWASHER
1/4 x 1" HEX WASHER HEAD
SELF DRILLING SCREW (4)
Installation:
1. Remove the protective plastic cover under the
hood toward the front of the vehicle (Fig. 1).
2. To access the mounting area, remove the 2
bolts that secure the hood latch assembly and
set the assembly aside without disconnecting
the cables (Fig. 2).
IMPORTANT! The hood latch assembly must
be remounted in the exact position it now
sits or the hood will not close properly.
Clearly mark the exact location of the hood
latch before removing.
3. Mount the speaker to the bracket (See
“Mounting the speaker to the bracket”
).
4. Mount the speaker bracket to the vehicle. First
secure the top part of the bracket using the
existing hardware indicated (Fig. 2). The
vehicle grill is flexible and can be pulled
forward to allow the bracket and speaker to fit.
5. Next secure the bottom of the bracket to the
vehicle using the four supplied 1/4 X 1” HEX
WASHER HEAD SELF DRILLING SCREWS.
It is recommended that you drill 3/16 pilot
holes using a carbide drill bit to install the
self drilling screws.
6. Be sure all hood latch cables are properly located, then re install the hood latch assembly.
Refer to vehicle manufacturers specifications for the correct torque value when tightening
the hood latch screws.
IMPORTANT: Make sure the two bolt heads line up with the guides you drew, so the
hood latch assembly reinstalls in the exact same position.
7. Extend WHITE (positive) and BLACK (negative) speaker wires to your siren amplifier and
connect as shown in the amplifiers instructions.
8. Replace the protective cover that you removed in step 1.
