Page 2
SA314: Installation
WARNING!The siren speaker wires must exit through
the bottom of the siren. The siren wire hole
is also the drainage hole. Improper
mounting will damage the driver and void
the warranty.
1. You will note that the bracket can be mounted on either side of
the hood latch. Using the holes indicated, (depending on
which side of the vehicle you wish to mount the siren) mount
the siren to the bracket using the mounting hardware supplied
.
2. On the radiator cross member (on either side of the hood
latch) you will find 2 holes, one square hole and one round
hole. Insert the extruded “U” nut into the square hole so the
extended screw sleeve faces the rear of the vehicle. The “U”
nut must clip onto the cross member and slide over so that the
screw sleeve lines up with the round hole.
3. Take the siren bracket with siren attached and place it into
position on the mounting surface. Secure it into place by
screwing the supplied hex head bolt into the “U” nut. Be sure
to run the vehicle horn wires behind the siren bracket.
4. Secure the siren bracket on top by screwing in the 3 supplied
self tapping screws. Use a drill with a socket attached.
5. Extend the white (positive) and black (negative) siren wires to
your siren amplifier and connect them as shown in the
amplifier’s instructions.
RADIATOR
SUPPORT
RADIATOR
HOOD
LATCH
Mounting holes
for passenger's
side mounting
"U"-Nut
Siren
Mounting holes
for driver's
side mounting
"U"-Nut
Siren
DRIVER
PASSENGER
"U" NUT
HERE
"U" NUT
HERE
Screw sleeve faces rear of vehicle
EXTRUDED “U” NUT
INSTALLING "U" NUT
Insert “U” nut
into square hole
