Page 2
IMPORTANT! The lightbar should be a minimum of 16" from any radio antennas!
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this product will not
interfere with or compromise the operation or efficiency of any vehicle equipment! Before returning the vehicle to active service, visually
confirm the proper operation of this product, as well as all vehicle components/equipment.
2014 - 2019 Ford Explorer &
2020 Ford Interceptor SUV:
This lightbar will mount on both
the driver and passenger side, on
the underside of the rear spoiler.
NOTE: The lightbar pictured is
shown here for example. Your
lightbar may look different but
will mount the same.
Preparing the spoiler:
1.
Each (half) lightbar will fit
between the outer end of the
spoiler and the curved
indentation
towards
the
inside. Figure 1 shows
where the lightbar will sit on
the vehicle. Figure 2 is a
closer view showing where the lightbar sits toward
the inside of the vehicle.
2.
Mount the rubber trim to each mounting bracket
(Fig. 3). Position the passenger side of the
lightbar in the exact mounting location with the
rubber trim making good contact with the window.
Clearly mark the two mounting hole locations onto
the spoiler and remove the bracket. Repeat for the
driver side of the vehicle.
3.
Drill pilot holes for the four lightbar mounting holes
you marked off in step 2 using a 7/64 drill bit.
4.
Drill a 7/16 wire access hole in the location
indicated in figure 1 on both sides of the vehicle.
5.
Following factory guidelines remove the spoiler from the
vehicle. Install both lightbar wire harnesses into the spoiler
following the factory wire harness. Make sure the end of the
lightbar harness with the connectors extends out of the wire
hole you drilled just enough to connect to the lightheads.
6.
NOTE: Adhesive pad and alcohol wipe not included in
2020 model vehicle.
Plug the wire harness into the lightbar.
Before mounting the lightbar use the supplied alcohol pad to
clean the area that the adhesive pad on the mounting bracket
will adhere to
(Not on 2020)
.
7.
Peel the paper backing off the adhesive pad on the mounting
bracket
(Not on 2020)
and mount the lightbar to the spoiler with the supplied 6 X 1/2 Phillips Pan Head Sheet Metal
Screws. Repeat for the opposite side of the vehicle and then reinstall the spoiler to the vehicle following factory specifications.
8.
Extend the wires to power and make all electrical connections using the information in the Wiring section on page 4. It is suggested that you
follow the vehicles factory wiring harness here.
WINDOW
WINDOW
6 X 1/2 Phillips
Pan Head Sheet
Metal Screw
RUBBER TRIM
ADHESIVE PAD
Fig. 4
Fig. 3
