Page 2
Installation:
1.
Remove the front bumper following manufacturers instructions.
2.
Cut both tow hooks off as shown in figure 1. This can usually be accomplished with
the tow hooks still installed on the vehicle however you may also want to remove
them to make the job easier.
3.
Loosen the two bolts that mount the passenger side tow hook bracket to the vehicle
and Install the Continuum mounting bracket as shown (Fig. 2). Tighten the 2 bolts
firmly to secure the tow hook bracket and mounting bracket to the vehicle.
4.
Insert the Continuum mounting stud into the hole on the mounting bracket and
loosely secure it with the supplied mounting hardware. If you are installing two
Continuums, loosely mount both (Fig. 3).
5.
Install the Continuum mounting bracket to the driver side of the vehicle while inserting
the driver side Continuum mounting stud(s) into the mounting holes on the
Continuum mounting bracket. Tighten the 2 bolts firmly to secure the tow hook
bracket and mounting bracket to the vehicle (Fig. 4).
6.
Extend the wires to your power
source and follow the instructions
that come with the light for
connection.
Holes provided
to mount 2 single
Continuums or
adjust height.
Tow Hook Mounting Bracket
Use existing tow
hook mounting hardware
Mounting
Plate
5/16 - 18
Elastic Stop Nut
5/16 - 18
Elastic Stop Nut
5/16 - 18
Elastic Stop Nut
5/16 Flat Washer
5/16 Flat Washer
Fig. 4
