Page 4
FIG. 2
COOLING FINS MUST BE
VERTICAL FOR MAXIMUM
HEAT DISSIPATION
5.00
5.25
INSTALLATION DIMENSIONS
ASSEMBLY
Страница 1: ...agnetic interference Therefore after installation of any electronic device it is necessary to test all electronic equipment simultaneously to insure that they operate free of interference from other components within the vehicle Never power emergency warning equipment from the same circuit or share the same grounding circuit with radio communication equipment All devices should be mounted in accor...
Страница 2: ...he cables depending on how you wire the system If you wire the lightheads individually they will have a different amp draw from lightheads wired in series Note All customer supplied wires that connect to the positive terminal of the battery must be sized to supply at least 125 of the maximum operating current and fused at the battery to carry the load 1 Route the interconnecting cables through the...
Страница 3: ...E 1 8 AWG MIN CUSTOMER SUPPLIED 50 AMP FUSE OR CIRCUIT BREAKER Customer Supplied NEG POS Power wire to be connected directly to module power source Single Pole Switch Ground for Low Intensity Only active in mode 2 HI LO CAB LIGHTS REAR AMBER LIGHT REAR BOX LIGHTS FRONT BOX LIGHTS AF6016A WIRING DIAGRAM 10 AWG MIN CUSTOMER SUPPLIED 8 5 7 Ground wire to be connected directly to battery or module gro...
Страница 4: ...Page 4 FIG 2 COOLING FINS MUST BE VERTICAL FOR MAXIMUM HEAT DISSIPATION 5 00 5 25 INSTALLATION DIMENSIONS ASSEMBLY ...
