Page 2
Bracket for
20" Continuum
(Shown)
Bracket for
10" Continuum
Fig. 2
This bracket will attach to the hood where the hood
hinges mount. The hood hinge mounting hardware will
be replaced with the supplied mounting hardware.
There is a specific driver and passenger side bracket
indicated by a D (driver) or P (passenger) at the end of
the part number stamped into the bracket. A 20”
Continuum is shown here. The 10” bracket mounts the
same.
1.
On the driver side, remove the 2 screws holding the
hood hinge on. Mount the driver side bracket using the
supplied M8 X 1.25 X 35MM Button Screws and plastic
spacers (Fig. 1) while re-mounting the hood hinge.
2.
Repeat step 1 for the passenger side and tighten all
hardware firmly.
3.
Mount the Continuum™ to the brackets using the
supplied 5/16 - 18 Elastic Stop Nuts and 5/16 Flat
Washers.
4.
Extend the wires to your power source and connect
as described in the lightbar manual. Wire guides
are provided on the mounting brackets to secure
the wires as required.
IMPORTANT! It is the responsibility of the
installation technician to make sure that the
installation and operation of this product will not
interfere with or compromise the operation or
efficiency of any vehicle equipment! Before
returning the vehicle to active service, visually
confirm the proper operation of this product, as well
as all vehicle components/equipment.
