Page 2
This mounting bracket will mount in the grille where the
license plate sits. The license plate will need to be removed
and relocated.
1.
Remove the license plate bracket and lower the grille from
the front bumper following factory specifications.
2.
Draw a line even with the indentation in the bumper across
each of the 4 tabs that the grille mounts to (Fig. 1).
3.
On the line you drew in step 2, centered within the width of
the tab, mark the center of the mounting holes you will drill on
the bumper area behind each tab (Fig. 1).
4.
Drill a 1/4” (or slightly larger) hole through the bumper in each
of the four spots you marked off in step 3.
5.
Slide the top and bottom of the mounting bracket under the
bumper (Fig. 2).
6.
Secure the mounting bracket to the vehicle using the
supplied 1/4 - 20 Nickel Plated Brass Nuts and 1/4 - 20 X 3/4
Phillips Pan Head Machine Screws (Fig. 3).
7.
Secure the light to the mounting bracket (Fig. 4).
8.
Replace the grill you removed in step 1. You will need to trim
some of the grille to fit the light (Fig. 5).
9.
Extend the power and ground wires to your power source and
connect following the instructions that come with the light.
Fig. 4
5/16 Flat Washer
5/16 X 18
Nickel PLD Brass
Elastic Stop Nut
