P82483 E
Sheet 5 of 7
WIRING INFORMATION:
Table 5: Speaker Voltage and Wattage Connecti
1/8
1/4
1/2
1
2
4
8
Input 25.0VRMS
E
D
C
J
B
-
A
Input 70.0VRMS
F
G
H
E
D
C
J
NOTE
:
Each letter corresponds to a fast on terminal located on the printed circuit board. Select voltage and wattage as shown in
Table 5.
Figure 1: Wiring Diagram
Figure 2.
1) Series ET Speakers and Series ET Strobe Speaker models have in-out wiring terminals that accept two #12 to #18 American Wire
Gauge (AWG) wires at each screw terminal.
2) Strip leads 3/8 inches and connect to screw terminals. Break all in-out wire runs on supervised circuits to assure integrity of circuit
supervision shown in Figure 2. The polarity shown in the wiring diagrams is for operation of the appliances.
GROUNDING:
For ET-1010/1080 install the appliance to a grounded backbox
(Per NFPA 70, the National Electrical Code) using the
lockwashers provided in hardware bag under the head of each mounting screw for the appliance.
WARNING: CHECK ELECTRICAL RATINGS SPECIFIED IN TABLE 1 AND 2 TO ENSURE PROPER ELECTRICAL INPUT.
BE SURE THAT SPEAKER WIRING IS CONNECTED TO SPEAKER TERMINALS ONLY AND STROBE WIRING IS CONNECTED
TO STROBE TERMINALS ONLY. CHECK TO INSURE THAT WIRING AT FACP IS CORRECT. IMPROPER ELECTRICAL
INPUT CAN DAMAGE THE PRODUCT OR CAUSE IT TO MALFUNCTION.
www.PDF-Zoo.com
firealarmresources.com
