P83937 E
Sheet 2 of 3
MOUNTING INFORMATION:
GASKET
CLEAR
P0LYCARBONATE
COVER
(4) #8-32 X 3/8" SOCKET
HEAD SCREWS
(4) RETAINING CLIPS
(4) #10 X 1-1/2"
(4) MOUNTING TABS
(4) 12 X 1"
INSERT THE (4) EXTERNAL MOUNTING
TABS INTO ENCLOSURE SLOTS AS
SHOWN. USING ENCLOSURE ASSEMBLY
AS TEMPLATE, PLACE AGAINST MOUNTING
SURFACE WITH CENTERLINE 80 INCHES
ABOVE FLOOR, MARK AND DRILL (4) HOLES
1/4" DIA. X 1" DEEP.
HORIZONTAL
CENTERLINE
OF ENCLOSURE
MOUNTING HEIGHT 80"
FRONT VIEW OF ENCLOSURE
CENTERLINE
NOTE
: AFTER ALL INSTALLATION PROCEDURES HAVE BEEN COMPLETED, INSTALL GASKET IN ENCLOSURE GROOVE NOW
PLACE COVER IN GROOVE AND POSITION THE FOUR (4) CLIPS IN THE SLOT CLOSEST TO EDGE OF COVER.
4 IN SQUARE, FLUSH BACKBOX MOUNTING INSTRUCTIONS
GASKET
A
B
C
D
F
E
CENTERLINE
TOP VIEW
1-1/4"
CONDUIT ENTRY HOLE
MUST BE FIELD DRILLED.
1. DRILL A PILOT HOLE
(MAXIMUM 1/2")
2. COMPLETE DIA. USING
A 1-1/16" DRILL BIT
OR HOLE SAW.
1.
Figure A is typical of a ¾ in. Rain tight conduit hub with neoprene o-ring threaded for rigid
conduit and imc. (O-Z/GEDNEY #CHM-75 or equivalent.)
2.
Figure B is typical of a ¾ in. female adapter (Carlton #E942 or equivalent).
3.
Figure C is typical of a ¾ in.-1/2 in. reduce bushing (Appleton #RB series or equivalent).
4.
Figure D is typical of a galvanized ½ in. conduit nipple.
5.
Figure E is typical of a ½ in. conduit lock nut.
6.
Figure F is typical of a 4 in. X 2-
⅛
in. Deep Square Backbox 9RACO190 or equivalent).
STAND-OFF INSTALATION
INSTRUCTIONS FOR AREAS WITH
FREQUENT WASHDOWNS
STAND OFF BLOCKS (4)
EXTERNAL MOUNTING
TABS (4)
CLEANING INSTRUCTIONS FOR
ENCLOSURE AND COVER
1.
Rinse with water to remove abrasive dust
and dirt.
2.
Wash with soap or mild detergent, using a
soft cloth (do not scrub).
3.
Rinse once more, than dry with a soft cloth
or chamois.
4.
Rinse with water to remove abrasive dust
and dirt.
5.
Wash with soap or mild detergent, using a
soft cloth (do not scrub).
6.
Rinse once more, than dry with a soft cloth
or chamois.
To remove grease or wet paint, rub gently with a
cloth wetted thoroughly with naptha then wash
and rinse. DO NOT USE RAZOR BLADES.
