1.
Connect (+) from 24VDC power supply to 24VDC (+) terminal on AFT-100.
2. Connect
(
-
) from 24VDC power supply to 24VDC (
-
) terminal on AFT-100.
Using a 12VDC Power Supply
1.
Plug power supply cord into 12VDC receptacle in bottom of AFT-100. Power supply plug polarity must match AFT-100 receptacle polarity (See
Figure 1). Recommended 12VDC power supply is the Wheelock EPS 1205.
CAUTION:
Exceeding specified maximum input voltage can lead to failure of the unit.
ANTENNA AND OUTPUT CONNECTIONS (See Figure 2):
1.
For use as background music source, connect
LINE OUT
to music input of paging system.
2.
For use as music-on-hold, connect
TEL
OUT
to music-on-hold input of telephone system. Do
not
connect to telephone lines.
NOTE
: This output can develop .5 Watt into 8 Ohms and may be too strong for telephone systems that incorporate line-level amplification stages
for music-on-hold. In these cases the
LINE OUT
send may also be used for the telephone system's music-on-hold input.
3.
If using an external antenna for FM reception, connect to ANT 300 ohms terminals.
NOTE
: Antenna is not required for AM reception.
Figure 1: 12VDC Power Supply Connection
Figure 2: AFT-100 Connections
P82214 D
Sheet 2 of 4
OPERATION (See Figure 3):
1.
Select AM or FM by sliding
BAND
switch to
AM
or
FM
position.
2. For
FM
program reception:
a.
Slide
ANT
switch to
INT
position when using telescoping antenna, or...
