Wheatstone TV-80, Техническое руководство

Страница: 104 / 120

A P P E N D I C E S
TV80 / Sep 98
Furniture Leg Set Assembly Instructions
The TV-80 furniture leg set is shipped in four sections:
a) two wooden endpieces
b) a front vanity panel, pre-attached to an interior access panel
c) a rear vanity panel
Note the leg set has already been pre-assembled with the TV-80
console at the factory, so all holes have been predrilled. The set is
subsequently broken down for shipping purposes. All that remains at
the client end is re-assembly.
a) Note the wooden end pieces: the curved edges face towards the front;
metal brackets have been pre-mounted on their inside surfaces; the bottom
edge of each piece is longer than the top edge. When set upright in the
correct orientation, the distance between them will equal the width of your
TV-80 audio console, and the front and rear vanity panels will span that
distance.
b) The double vanity panel (the one already attached to the unfinished
wooden ACCESS PANEL) is the front spanning piece. Its formica surface
faces front; the cherry strip is its bottom edge and rests on the floor. Note
the metal angle piece running the entire length of the access panel’s top
edge—this attaches to the bottom of the TV-80 console.
c) The single vanity panel is the rear spanning piece. Its formica surface
faces to the rear. The cherry strip is its bottom edge; when in place it leaves
a 3/4” gap between it and the floor. This is for wiring cable access.
FIELD ASSEMBLY CONSISTS OF FIVE BASIC STEPS:
1) Position the two side pieces and mount the ACCESS PANEL
(with its attached front vanity panel) to them, by screwing through the
side piece front metal brackets directly into the predrilled holes on the
access panel’s (inside) surface, using the wood screws provided.
2) Mount the REAR VANITY PANEL to the rear metal brackets of
the side pieces. Note this panel is attached using finished cupwasher
screws that go into pre-tapped holes on the side pieces’ rear metal
brackets. Remember there will be a 3/4” gap between the rear panel’s
cherry trim strip and the floor.
3) With all screws tightened and the leg set safely assembled as a
rigid structure, it is time to place the TV-80 console onto the leg set.
REMEMBER THE CONSOLE IS HEAVY! Depending on main-
frame size, it can easily weigh 600+ pounds. We recommend six
people to lift it in place.
When properly in position (see drawing next page) the console’s
wooden endpieces will rest on the leg stand’s side pieces, and will span
the premounted REAR metal brackets. Front to rear position is deter-
mined by the predrilled holes in the bottom of the console’s mainframe,
which correspond to the holes in the metal flange running the full length
of the ACCESS PANEL’s top edge. NOTE also the rear metal plates
on the inside top of the leg stand side pieces. Once the console is
screwed down, these swing up and are screwed to the inside of the
console wooden side pieces to further secure the completed structure.
page A – 9
!
Refer to the drawing
on the next page