Model # ECOM-KCH
Please call for replacement parts or assistance:
1-866-942-5362
Whalen Furniture Manufacturing
Page 4
Factory No. 16936
Assembly Instructions
1.
Unpack the unit and confirm that you have all the hardware and required parts.
2.
Lay the Chair Backrest (A) on a smooth and protective surface with the threaded holes facing up.
3.
Attach the Seat Frame (B) to the middle rail of the Chair Backrest (A) with the end dowels fully inserted.
Make sure that the
Seat Board
will face up when the unit is turned upright. Insert and screw the 3-1/4”
Bolts (2) with Lock Washers (3) and Flat Washers (4) through the drilled holes on the seat frame at rear
corner blocks and loosely tighten into the threaded inserts on the Backrest. As shown.
4.
Secure the Seat Frame (B) to the Chair Backrest (A) by inserting two 1-1/2” Bolts (1) with the Washers
(3 and 4) through the drilled holes on the rear rail of Seat Frame. As shown.
NOTE
: DO NOT fully
tighten the bolts.
Ø5/16” x 3-1/4” Bolt
(4 used in this step)
②
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
Lock Washer
(6 used in this step)
③
Flat Washer
(6 used in this step)
④
3
4
2
4
1
3
B
A
B
A
Ø5/16” x 1-1/2” Bolt
(2 used in this step)
①
