Model # ODUS-CGTD
Please call for replacement parts or assistance:
1-866-942-5362
Whalen Furniture Mfg., Inc.
Page 10 Factory No. 15548
Assembly Instructions
16.
Align and attach the assembled Upper Stretchers (M) to the upper corners of Left Side Frame by
inserting the M6 x 12 mm Black Bolts (4) with the Black Washers (6 and 7) through the Metal Brackets
(14 and 15) and screw into place. Make sure that the top surfaces are flush with each other.
NOTE
: DO NOT fully-tighten the bolts initially until all the bolts are ready to assemble. To avoid
causing damages to the thread, DO NOT over-tighten the bolts.
17.
Fasten the Back Lower Stretcher (N) to the Left Back Panel (D) using two M6 x 12 mm Black Bolts (4)
and two Black Washers (6 and 7). As shown.
18.
Align and attach the Fixed Shelf and Support (K and L) to the Left Side Panel (E) by using two Wood
Dowels (3) and three Cam Locks (1). Make sure that the Cam Lock on the Shelf Support (L) will point
towards the back of the unit.
19.
Repeat the same procedure to attach the assembled Right Side Frame at the opposite end.
20.
Stand the assembled unit upright.
21.
Position the Glass Top (O) onto the assembled unit so that the threaded sockets underneath the metal
plates overlap the drilled holes simultaneously. Insert four 32 mm Bolts (5) with the Black Washers (6
and 7) through the drilled holes on both Top Panels (A and F) and insert four 35 mm Zinc Bolts (8) with
the Zinc Washers (9 and 10) through the Upper Stretchers (M) and securely screw into place.
22.
Plug Cam Lock Covers (11) and Cam Lock Caps (12) onto the visible Cams Locks to conceal the Cams.
N
C
H
F
O
O
O
8
9
10
5
6
7
