6
Warning
!
Cleaning products that contain abrasives can damage the pedicure spa. Use only non-abrasive
products to clean your spa.
Always check with your state board for required cleaning and disinfecting procedures. It is extremely important to clean and
disinfect your pedicure spa after each pedicure, after the last pedicure of the day, and once a week for overnight cleaning.
Regular cleaning will help keep your pedicure spa in good working condition. Proper and continuous cleaning will kill harmful
bacteria and germs that can cause infection. To clean your pedicure spa equipped with pipeless technology, follow these
easy steps:
After use upon each patron, each pipeless pedicure spa shall be cleaned and disinfected in the following manner:
(1) All water shall be drained from the spa basin.
(2) Remove 2 piece inlet housing & impeller.
(3) Scrub all visible residue from the inlet housing, impeller, inside walls of the basin, and/or other components and the
areas behind or under each with a clean brush and liquid soap (labelled as such on soap product) and water. Rinse with
clean water.
(4) Re-insert the properly cleaned inlet housing & impeller.
(5) Refill the basin with clean water and circulate the correct amount (read the label for mixing instructions) of the EPA-
registered hospital-liquid disinfectant which the label claims is a bactericide, fungicide, and virucide, through the basin for at
least 10 minutes.
(6) Drain, rinse and wipe the basin dry with a clean paper towel.
(7) Record this procedure in the pedicure-cleaning log. The log shall contain the date and time of
each cleaning, initials of the person who completed the procedure, and shall indicate that the cleaning was done after a
client.
At the end of every day and after performing the procedures provided in subsection (b) (1 through 6) and after the
last client, each pipeless pedicure spa shall be cleaned and disinfected in the following manner:
(1) Fill the basin with warm water and detergent (labelled as such on detergent product) and circulate the detergent through
the spa system for at least 10 minutes.
(2) Drain the detergent solution and rinse the basin.
(3) Refill the basin with clean water and circulate the correct amount (read the label for mixing instructions)
of the EPA-registered hospital-liquid disinfectant which the label claims is a bactericide, fungicide, and virucide, through the
basin for at least 10 minutes.
(4) Drain, rinse and wipe the basin dry with a clean paper towel.
(5) Allow the basin to dry completely.
(6) Record this procedure in the pedicure-cleaning log. The log shall contain the date and time of
each cleaning, initials of the person who completed the procedure, and shall indicate that the cleaning was done at the end
of the day.
At least once each week, after completing the procedures provided in subsection (c) (1 through 3), and the
disinfectant solution in each pipe-free pedicure spa shall not be drained and the following procedures shall be
followed:
(1) The unit shall be turned off and the disinfecting solution shall be left in the unit undisturbed for 6 to 10 hours.
(2) After the disinfectant solution has been sitting between 6 to 10 hours, drain, rinse and wipe the basin dry with a clean
paper towel.
(3) Record this procedure in the pedicure-cleaning log. The log shall contain the date and time of each cleaning, initials of the
person who completed the procedure, and shall indicate that the cleaning was done weekly. The pedicure-cleaning log shall
be made available upon request by either a patron or a state board representative. A violation of this section may result in an
administrative fine and/or disciplinary action.
PIPELESS JET CLEANING
Pure-Flo Pipeless Spa Cleaning and Disinfecting Procedure
3
!
Warning
