• Install and use this filter on cold water only. Do not use on water lines exceeding 100° F
(38° C). Water pressure minimum is 10 psi and the maximum is 90 psi.
• Protect unit from direct sunlight and freezing temperatures.
• Keep unit clean with soap and water. Do not use spray cleaners or insecticides near unit.
• Intended for indoor, non-commercial use only.
• For extended periods of non-use turn the water off and remove the filter cartridge. Place
the cartridge in a plastic bag, seal and refrigerate.
• Tubing and housing dimensions are based on outside diameters (OD). For water line sizes
other than those listed, consult a plumber or hardware store.
• Before using the water, flush the new filter for 2 minutes.
• Change cartridge at manufacturer’s suggested interval or sooner if you notice a change in
colour, taste or low water pressure.
• This filter is not a water purifier and is not intended for use with contaminated water.
• Comply with all state and local laws regarding the installation of water treatment devices.
• Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• The rubber O-ring provides the watertight seal between the cap and the housing. It is
important that the O-ring be properly seated in the groove in the housing or a water leak
could occur.
• The contaminants or other substances removed or reduced by this water filter device are
not necessarily in your water.
• DO NOT use wrench to tighten housing.
• Use wrench ONLY for housing removal
PLEASE NOTE
Distributed by Water Filters Australia Pty Limited ABN: 78 089 574 489
Unit 1, 91-93 Old Pittwater Road, Brookvale NSW 2100
PO Box 636 Freshwater NSW 2096
Phone: 61 2 9905 6211
Fax: 61 2 9905 6255
Email: info
@
waterfiltersaust.com.au
Web: www.waterfiltersaust.com.au
For all enquiries call the National Customer Service Centre on:
1300 785 355
