Wexiodisk WD-90 DUO, Инструкция по установке и эксплуатации, Страница: 20 / 96

WD-90 DUO Rev. 2.0 (202204)
Installation instructions
16
3.4.3 Fitting the condensation unit
On delivery of dishwashers with condensing unit, the condensing unit is folded
down over the hood and secured with protective transport plates. N.B.! The dish-
washer should be adjusted so that it is standing level when assembly of the con-
densing unit starts
1. Loosen and remove the upper back panel at the rear of the dishwasher.
2. Loosen and remove the screws (c) that hold the protective transport plate
(b) against the condensing unit (a).
3. Loosen and remove the screws (d) and nuts that hold the protective trans-
port plate against the brackets at the back of the dishwasher and remove
the protective transport plate (b). Possibly need to loosen the contact
(JM15) on the power cable to the condensing unit.
4. Lift the condensing unit into an upright position so that it can be attached
to the brackets (5) on the back of the dishwasher. The condensing unit
should not be pulled but lifted into place so that the sunken seal high up on
the back of the dishwasher is not damaged or warped.
5. Attach the condensing unit to the brackets (5) on the dishwasher using the
screws which were previously removed. Check that the condensing unit is
perfectly level. Tighten the screws.
a
b
b
c
c
d
d
25-4-01-008