2-7
2.3.4 Powering Down the
VMT10
Always shut down the
VMT10
as follows:
1. Power down the device using the ignition input or the [Power] key.
2. Remove the cable cover.
3. Disconnect the device from the DC supply voltage (pull the plug).
2.4. Handling the
VMT10
2.4.1 Starting the
VMT10
Press the Power button to turn on the
VMT10
. If the
VMT10
does not power on,
check the power adapter has been connected normally and you should try again.
Figure 2-7
Starting the
VMT10
2.4.2 Configure and calibrate the touch screen
PenMount touch screen is the most popular touchscreen on the market. Penmount
software support a wide range of configuration. You can use this software to configure
and calibrate the touch screen. When the operating system is started, you can see the
icon of
Penmount Monitor
in the notification area.
Figure 2-8
icon of Penmount Monitor
When the
VMT10
is powered on, it‘s
operating system starts up. A splash screen
(figure 2-7) appears for a short period of time
followed by the Windows 7 window.
This section offers the basic procedures
of
VMT10
using.
1
2
3
4
