Wetelux 84 26 92, Инструкция по эксплуатации

Страница: 17 / 26

13
Using
Mounting/Installation

Remove the four screws from rear side of the LED floodlight and open
the floodlight.

Turn off the nut (A) from the cable gland
(5) and lead the power cable through the
cable gland at the side of the housing.
Then turn on the nut again.

Connect the three wires of the power
cable, as shown on the right bottom pic-
ture, with the lustre terminal which is lo-
cated inside the housing of the LED flood-
light. Then secure the power cable with
the strain relief (B).

Reassemble the housing in
reverse order and secure it
with the four screws.

The LED floodlight can be
used indoors as well as out-
doors. The LED floodlight is
splash proof (IP44).

Install the wall mount (3) with
two or three suitable screws
securely to an appropriate
place.

Tilt the floodlight to the desired angle and tighten the screws at the
hinge of the wall mount to secure its position.
Note: Before installing the floodlight permanently to a wall, check the
proper functionality and the field of view of the motion sensor (4). Se-
lect a suitable place of installation in order to have the floodlight acti-
vated in time when passing the motion sensor.
N L
B
A
5