5
Wet Sounds STX MICRO Series Amplifiers Operations / Installation Manual
CONNECTIONS – STX MICRO-1
BEFORE ANY INSTALLATION IS BEGUN – DISCONNECT THE BATTERY!
7. Power (RED) Connection.
It is recommended that the power connection
be run directly to the vehicle’s battery. Run a minimum 8 Gauge wire with
a fuse at the battery. Be sure that the outboard dual ATC fuse holder stays
close to the amplifier. FAILURE TO USE THE SUPPLIED OUTBOARD FUSES IN
THE INSTALLATION IS DANGEROUS AND WILL VOID THE WARRANTY!
8. Ground (BLACK) Connection.
This should be connected to chassis ground
where possible. If the vehicle does not have a chassis ground, run a wire
directly to the negative side of the battery.
9. Remote Turn-On (BLUE) Connection.
This should be connected to a wire
that su12V when powered on. The BLUE wire must r12V
for the amplifier to power on.
10. Speaker (Black and Black/White) Connections.
Connect these to
the Positive and Negative terminals of the subwoofer. Be sure the total
impedance of the subwoofers does not fall below 2 Ohms!
11. Input.
Connect this to the output of the source unit or the pass-through
output of the STX MICRO-4. This connector is designed to accept a 3.5mm
male plug. An RCA style adaptor such as the Wet Sounds WW-RCA-3.5mm
2ft can be used if the source has RCA style connectors.
