Cast Mount Tower Version using the TC3-S clamp for quick disconnect
and swivel function.
Step 1: Attach Male Connector (10) from clamp base to Female Connector (11)
Step 2: Push connector into center hole of speaker as you place clamp base
onto the speaker housing. Insert 4 bare wires down into this hole as well. These
wires are only used if you are adding the LED speaker rings. (please see LED
speaker install instructions for LED install) Please make sure the grommet (12)
is seated properly.
Step 3: Attach two LONG Allen Bolts (4) through the clamp base and tighten
into the housing. Please make sure these are tight. It is also recommend to use
a Blue Loctite on these bolts.
Step 4: Clamp Bottom (3) and Detachment Plate (5) are already connected
together. Remove allen bolts (6) that hold the detachment plate (5) to the clamp
bottom (3). Clamp Top (2) and Clamp Bottom (3) will not be used for a cast
tower mount.
Step 5: The detachment plate (5) will be hard mounted to a cast tower. Butt
connect speaker wires from detachment plate connector (4) to the speaker wires
from the cast tower. Red is positive and Black is negative.
Step 6: Push wires into center hole back into the tower and attach the
detachment plate to the tower.
Step 7: Please make sure the male speaker plug (7) and female speaker plug (4)
are lined up properly. The male speaker plug (7) inside the clamp base can
rotate. Please rotate this so that it is facing the proper direction. There is a U
shaped groove on the female that lines up with a boss on the male.
Step 8: Insert speaker with base onto detachment plate. Slide on detachment
fork (17) and allen bolt (19) and tighten allen bolt so the speaker does not
move.
Step 9: The swivel clamp also allows you to remove the speaker from the tower
in seconds. Loosen the allen locking bolt (19) and remove the detachment fork
(17). Once removed, the speaker will disconnect from the clamp. The
detachment plate remains on the tower. To reinstall, line up the male speaker
plug (7) so that it is centered and insert the speaker by plugging the connector
together and reinstalling the detachment fork.
