１０
Function of figures 2 as below:
1.
Digital display meter of voltage
：
when machine is not working, it display preset voltage, when machine is
working, it display the actual welding voltage;
2.
Digital display meter of current
：
to display the actual welding current
；
3.
Adjusting knob of welding voltage: to adjust the welding voltage;
4.
Adjusting knob of welding current: to adjust the welding current;
5.
Plug seat of welding torch: plug of welding torch, Europe type interface;
6.
Over heating indicator light: when the welding machine is working in high temperature environment and
working overload, the temperature of radiator is higher than 75
℃
±5
℃
, the protection circuit begin to work, and
then output current will be cut. At the same time, the cooling fan go on working, after the temperature get down,
the welding machine will work normal again. The indicator light will also light when the air flue jammed or cooling
fan damaged.
7.
Change-over switch of welding & gas checking: before welding, to adjust the shield gas flow, turn it on "gas
checking". Turn it on "welding" position when welding.
8.
Change-over switch of self-lock & non-lock: when it is put on"self-lock", press the torch button and then the arc
can be stroke, loosen the button, welding will keep on normally, press the button again, welding finishes. When it is
put on "non-lock", press the button, welding begins, loosen the button, welding finishes.
9.
Manual wire feeding button: press it and the wire feeder work. Wire feeding speed can be adjusted by welding
current. When wire diameter is small, the wire feeding speed should be slow to prevent bending the wire.
10.
Arc characteristic adjust knob: Gas welding, use to adjust and control the different period current rate of
melting drop process, adjust the knob directly affect the arc soft/hard, spatter, welding shape and arc stability.
Recommend use standard characteristic.
Note: large spatter if arc hard, otherwise small.
11.
-(power output negative): use to connect the earth cable;
