Westweld LTD
Office:
No.51, Xuefu Avenue, Nanan, Chongqing 400074 , China
10
Figure 5
Figure 6
D.
Signal and power supply interface.
1. At the behind of the wire feeder, there are two connecters, The 2-pins are wire feeder
signal connected to the wire feeder interface of the cabinet. This signal is a short signal, This wire is
often closed and not 24V input.
2. The other 3-pin connecter for the power supply, Input AC220V power.
E.
Operation panel
1. The home page value shows the wire feeding speed, adjust it through the upper and lower
keys, and keep the run button green state when using it.
2. Manual wire feeding: After press, the wire feeding machine starts to feed wire, and the
manual wire feeding speed depends on the background setting (Figure 7)
Figure 7
Figure 8
3. Press setting to set the parameters of wire feeder.
4. Press save when all Settings are completed (Figure 8)
5. Set the feed speed of the page as the default feed speed, that is the switch remains
unchanged.
6. Start-up delay: The delay time before feeding.
7. Withdrawal length and supplement length: set according to the actual usage.
When the welding switch released, the wire feeder will first withdraw a length then stop feeding.
When the welding switch pressed, the wire feeder will supplement a length then start feeding. If
the wire is too long before welding, please set the withdraw length longer than the supplement
length.
