![background image](http://html.mh-extra.com/html/westunitis/wuz-01b-nb01/wuz-01b-nb01_quick-manual_966284013.webp)
13
2.
Raise the battery holder and insert the battery.
Battery
Switch
Cover
1.
Move up the switch and open the cover.
Inserting and replacing batteries
● Inserting method
The battery can be replaced without turning off the power.
3.
Close the cover and lower the switch.
● Replacement method (hot swap)
* The manufacturing number is provided
at the inserting section of the battery
(cover section).
Be careful with the
battery direction.
1.
Hold the button ❶(the foremost button) for longer than 1 second.
2.
Remove the used battery. Then within 15 seconds, insert the charged battery.
When the hot swapping succeeds, the power LED starts blinking in 2-second intervals
again. If the hot swapping fails, the power LED turns off.
3.
Press the button ❶(the foremost button).
Resume the paused application from where it is stopped.
The power LED starts blinking. After a few seconds, it switches to the slow blinking state
with intervals of approximately 2 seconds.
Hold down the button for a while.
Power LED
Battery holder