PILOT4
Owner’s Manual
Page 10 of 12
Outboard Engine (C)
Refer to the engine manual. Always flush the cooling system with fresh water after use.
Cleaning (C)
Use as few cleaning agents as possible, do not discharge waste agents into the water, and:
Clean your craft preferably on land
Avoid scratching of the hull, use a high-pressure water machine
Do not use abrasive cleaning or polishing methods
Do not use solvents or aggressive detergent
Always rinse down after use
Winter Storage (C)
Refer to the engine manual for winterising the engine, otherwise generally include the
following:
Remove, charge and store the battery in a dry, ventilated place protected from frost
Grease the steering gear
Remove all water from the craft and protect it from rain, preferably stored inside
Inspect all areas, fixtures & fittings replacing any doubtful components
Electrical System (W)
No electrical system has been supplied on this boat by the boat builder and any subsequent
electrical system installed on this boat is outside the control and responsibility of the boat
builder. Notes and information on any subsequent electrical installation on this boat should
be kept with this manual and passed on to any subsequent owner.
WARNING, NEVER:
Work on electrical systems while the system is energized
Modify a craft’s electrical system or relevant drawings; installation, alterations and
maintenance should be performed by a competent marine electrical technician
Alter or modify the rated current amperage of fuses
Install or replace electrical devices with components exceeding the rated current
amperage of the circuit
Leave the craft unattended with the electrical system energized, except automatic
bilge-pump, fire protection or alarm circuits
Additional Manuals (C)
Any additional equipment, fixtures and fittings should have their instructions/manuals stored
with this manual and passed on to any subsequent owners.
