Westone Bluetooth Cable 2.0, Руководство пользователя

Страница: 9 / 13

ADDITIONAL INSTRUCTIONS AND TROUBLESHOOTING
To pair the cable to a new device, follow
these steps:
1. Ensure that the cable is in pairing mode.
2. There are two (2) ways to enter pairing mode.
a. Hold down the power button on the cable
for five (5) seconds while turning on the
device you wish to pair the cable with.
b. Clear the Paired Device List (PDL) by pressing
and holding down the Volume Up (+) and
Volume Down (-) buttons on the control
module together for eight (8) seconds.
3. The cable will switch off if it is not connected
to a device after five (5) minutes. A voice prompt
will indicate “Power Off”.
4. The cable will automatically try to reconnect
to the last device it was paired with unless
the PDL has been cleared.
5. The operation and enabling of Voice Search/
Siri can only be done on devices that
support those functions.
6. When the cable battery power has reached 30%
of remaining life, the indicator light will turn red
for all events and a voice prompt will indicate
“Battery Low”. This voice prompt will repeat
until all power is drained.
If the cable fails to pair to the selected device,
follow these steps:
1
. Disable and then enable the Bluetooth
setting on the device, then search for
“Westone BT 2.0” again.
2. Reboot the cable by turning it off and then
on again.
3. Clear the Paired Device List (PDL) by pressing
and holding down the Volume Up (+) and
Volume Down (-) buttons on the control
module together for eight (8) seconds.