
4
PRODUCT MANUAL
1800 358 101
www.westlab.com.au
+64 9 553 3677
www.westlab.co.nz
646 568 5391
www.westlab.com
1 877 822 1455
www.westlab.com
Australia
New Zealand
United States
Canada
4. Installation & Operation
4.1 Installation
1. Remove the upper packaging gently and take the roller out by holding the unit from
the bottom.
2. Ensure that all the packaging accessories are removed from the product prior to
using the roller for the first time.
ATTENTION: Keep all the packaging in safe storage for at least two years after the
purchase for warranty purposes.
Connecting the power adaptor
1. Connect one side of the power adaptor to the rear side of the device and the other
to the power supply as indicated in the figure below
2. Ensure that the power switch is OFF when connecting the power adaptor
3. Switch the main power supply to ON
ATTENTION: Ensure that the tubes are distributed evenly prior to use.
4.2 Operation
Operating the Start/Stop button
1. Once the required speed and time values are set, press the ‘Start/Stop’ button to
start the operation. The speed will gradually increase from zero RPM to 30 RPM.
2. Press the ‘Start/Stop’ button again to stop the ongoing operation. The speed will
gradually decrease to zero RPM.
ATTENTION: There is no provision to change the speed value.
5. Product Disposal
In the case that the product is to be disposed of, the relevant legal regulations are to
be observed.
ORDERING WITH
WESTLAB IS EASY
Online
www.westlab.com.au
Order online with our easy
Express Order form for fast,
secure ordering.
Phone
1800 358 101
Speak to one of our friendly,
efficient staff from
8.00am - 5.00pm (Mon/Fri)
24 hours, 7 days a week
convenience.