40
41
CARE AND CLEANING
CARE AND CLEANING
WARNING
CAUTION
Do not remove the slide mechanism on the separate grill
underbench model (WVE655). The grill dish can easily be
removed for cleaning.
Removing the side racks
1. Grasp the middle wire at the front.
2. Pull firmly inwards while pushing back.
Slides (Telescopic runners)
(For applicable models only)
•
Do not subject slides to temperatures greater
than 300°C.
•
Do not place slides in a dishwasher
•
Do not use a knife or sharp object to clean slides.
•
Do not add oil or any other lubricant to slides.
Removing and replacing the oven back light and
side light (where fitted)
•
Turn oven light glass anticlockwise to remove it for
globe replacement.
• To remove side light, place a spoon under the light
glass and lever off. Replace globe and snap glass
cover back into position.
• A special high temperature resistant globe should
be used. This can be purchased from Electrolux
Customer Care Centre.
NOTE: :Light globes are not covered by warranty
WARNING
WARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
Releasing the grill element
WARNING
WARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
Retaining wire models - The upper grill element is secured
with a hanger clip which can be removed to help clean
the oven cavity ceiling. To remove the hanging clip push
the sides of the clip in the direction of the arrows. After
cleaning, raise the grill element and secure clip back
into position.
NOTE: Diagram shows a grill in oven model. The
procedure is the same for separate grill models which use
the same hanger clip in the grill compartment.
Rotating latch models - rotate latch 180
degrees and the
grill element will drop down freely. After cleaning, raise
the grill element and secure by rotating the latch back 180
degrees.
CARE AND CLEANING (CONTINUED)
Cleaning the triple glazed oven door
(on selected models)
WARNING
CAUTION
Do not lift the door by the handle. Rough handling will
cause glass to break.
Removing the oven door
TIPS & INFORMATION
IMPORTANT
Your oven is equipped with a door that can be
disassembled in order to clean all the panes of glass.
Remove the door before cleaning.
• Open the door fully to access the hinges then rotate
the ‘stirrups’ on both hinges fully towards the oven.
• Slowly close the oven door until it stops against the
‘stirrups’ (about 45°).
45
• Grasp the oven door with a hand each side of the
door and remove it from the oven by pulling it
towards you.
•
Lay the oven door with the outer side facing
downwards on something soft and flat (for example
a blanket on a kitchen table) to prevent scratches.
Removing oven door top trim
• Take hold of the grid embossed sections of the door
trim at each end and press inwards to release the
clips. Remove the door trim by pulling it towards you.
