Westinghouse WSU6603, Руководство пользователя, Страница: 14 / 28

Frost precautions
Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage caused by frost.
Moving the appliance
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the appliance and the hoses.
4. Do not tilt the appliance during trans-
port.
WHAT TO DO IF…
The appliance does not start or stops dur-
ing operation.
If there is a fault, first try to find a solution to
the problem yourself. Refer to following
charts. If you cannot find a solution to the
problem, contact your dealer or the Cus-
tomer Care Centre.
With some malfunctions, the display
shows an alarm code:
•
- The appliance does not fill with wa-
ter
•
- The appliance does not drain the
water
•
- The anti-flood device operates.
Warning! Switch the appliance off
before you do the suggested corrective
actions.
Malfunction Possible cause Possible solution
The appliance does
not fill with water The water tap is closed. Open the water tap.
The filter in the water inlet hose is
blocked. Clean the filter.
The installation of the water inlet
hose is not correct. The hose can be
kinked or squashed. Make sure that the installation is cor-
rect.
The water tap is blocked or restric-
ted with limescale. Clean the water tap.
The water pressure is too low. Contact your local water authority.
The appliance does
not drain the water There is a blockage in the sink spi-
got. Clean the sink spigot.
The installation of the water drain
hose is not correct. The hose can be
kinked or squashed. Make sure that the installation is cor-
rect.
The anti-flood device
operates Close the water tap and contact
your Customer Care Centre.
The program does
not start The appliance door is not closed. Close the door.
The START button has not been
pressed. Press the START button.
Mains plug is not connected. Plug-in the appliance to the mains.
The delay start is set. • Cancel the delay start.
• Wait until the countdown of the
delay start is completed.
The fuse has blown out in the
household fuse box Replace the fuse.
After the check, switch on the appliance.
The program continues from the point of in- terruption. If the malfunction occurs again,
contact your Customer Care Centre.
14 westinghouse