Westinghouse WSE6070, Руководство пользователя

Страница: 10 / 40

10 installation
GENERAL iNStALLAtioN
When correctly installed, your refrigerator should:
• Have adequate clearance to the back, sides and
top for air circulation
• Be aligned to the surrounding cupboards
• Have doors that will self close from a partially
open position
CLEARANCES ARoUNd YoUR REfRiGERAtoR
Your Side by Side refrigerator can be installed between
cupboards or fixtures but you must allow for the following
spaces around the cabinet
• Allow a minimum of 5 millimetres clearance on both
sides (see diagram 1)
• Allow a minimum of 5 millimetres clearance above
hinge covers (see diagram 1)
• Allow 10 millimetres clearance at the back of the
refrigerator (see diagram 1)
Diagram 1
Recommended
minimum airspace
CABINET
5mm
10mm
10mm 35mm
5mm
DOORS
• Allow a 250 to 350 millimetre minimum clearance on
the hinge side of the doors, if you place the refrigerator
next to the wall This will make cleaning easier (refer to
diagram 2)
• Make sure that cupboards or fixtures do not stick out
further than the refrigerator cabinet (refer to diagram 2)
iNStALLAtioN
The refrigerator should arrive with the front rollers wound
down We recommend that the appliance be tilted
backwards by about 10 to 15 millimetres, this will allow
the doors to self close providing a consistent door seal
To do this follow the instructions below
Height adjustable
front rollers
Fixed rear rollers
10 -15mm
When you want to install your appliance, take the
following steps
1. Roll the refrigerator into it’s final position.
WARNING
The rollers are designed for forward or backward
movement only They are not castors Moving the
refrigerator sideways may damage your floor and
the rollers
2
If the refrigerator is not tilted back you can adjust the
two front rollers by adjusting the large plastic roller
nut (refer page 11) You may need two people, one
to adjust rollers and one to tilt the refrigerator slightly
back to take the weight of the appliance off the front
rollers This will increase or decrease the height of the
rollers One turn of the nut will change the tilt of the
refrigerator by approximately 5mm
3 If the cabinet is level, then the side walls should be
plumb or vertical If the cabinet is built in or partly built
in check the alignment of the cabinet side against
the cupboard
Diagram 2
25
0mm
350mm
maximum
cupboard depth