Westinghouse WRCG930SB, Инструкция по установке и эксплуатации, Страница: 13 / 20

13
USING YOUR RANGEHOOD
USING YOUR RANGEHOOD CARE & MAINTENENCE
• Best results are obtained by using a low speed for
normal conditions and a high speed when odours are
concentrated.
• Turn the hood on for a few minutes before you start
cooking.
• The hood should be left on for a minimum of 5
minutes after cooking or until all odours have
dispersed.
• The control switches are located on the front panel of
the unit. See below
1
2
Turning on/off the lamp
Press button to turn on the lamp, press once again
to turn off the lamp.
Turning on/off the fan
Press any fan level button to turn on relatived fan level.
Press once again to turn off the fan. Or press other fan
level button to change the fan level.
Turbo function
When the range hood is working at fan level 3, press and
hold the button for fan level 3 for 3S, then all fan level
button will begin to twinkle and turn on turbo function.
Turbo function will work for 5 Min and then step down to
fan level 3. When turbo function is activated, press any
fan level button will deactivate turbon function.
Delay end
When the range hood is working at fan level 1or fan level
2, press and hold relative button for 3S, then relative
fan level button will begin to twinkle and activate delay
end function.
After 5 Min, the range hood will be off automatically.
Filter check
When the motor on time reachs 50 hours, the light
control button will twinkle when the range hood is on.
Press and hold lamp control button to stop the twinkling
and reset counting.
NOTE. This product is fitted with a safety cutout device.
If the cooker hood is installed to close to the cooktop,
flambe cooking, operating the cooktop without cooking
utensils and blocked filters may activate the safety cutout
device. If the hood stops during operation, correct the
faults and allow time for the safety cutout device to reset,
the cooker hood will then function correctly.
WARNING
CAUTION
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions
to ensure the best possible result is achieved without
damage
Cleaning the hood
• Clean the outside of the hood using a damp cloth and
a solution of water and mild washing up liquid. Clean
stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless
steel. To ensure the best results also use an even
pressure and follow the grain of the stainless steel.
Use of a soft cloth reduces the risk of scratching. If
the cloth is wet ensure that a dry soft cloth is used
to wipe down the surface and apply stainless steel
protector to reduce the risk of any surface rust
appearing.
• Never use corrosive, abrasive or flammable cleaning
products or products containing bleach.
• Never insert pointed objects in the motors protective
grid.
• Only ever clean the switch panel and filter grill using a
damp cloth and mild washing up liquid.
• It is extremely important to clean the unit and change
the filters at the recommended intervals. Failure to do
so will cause grease deposits that could cause a fire.
Removing the metal grease filters
• Push the grease filter and then pull it down and out.
1
2