Page 5
OPERATION
• Insert included lithium cell battery into battery holder at the back of the scale. Open the cover,
install the battery into the holder with “+” polarity facing up and close cover.
• Place the scale on hard and flat surface. A clean table or counter is best. Do not place on soft
surfaces as accuracy may be compromised.
• Press TARE button to turn on the scale. It is ready for use when the LCD screen shows “0”.
• Use “MODE” button to select “g” grams, “oz” ounces for weight measurements. For volume
measurements of water or milk, use ““ml” or “cup”.
NOTE:
For volume measurement of water or milk, be sure that the correct word “water” or “milk”
appears in the upper portion of the display depending on which you are trying to measure.
• Place the included collapsible bowl or other container/storage item you want measured on the
platform of the scale and the measurement will appear on the screen.
NOTE:
The measurement will display for about one minute and then switch off automatically. You
can also switch off immediately by pressing the TARE button down for approximately two
seconds.
• If you want to use the TARE function, press the TARE button again to clear the results of the
container/storage item just measured.
NOTE:
When using without the included bowl if the item or items weighed exceeds 100g the
word “Tare” will appear in the display along with “0” with the unit of measure you have
selected. If the item, or items weighed is less than 100g, only “0” and the unit of measure
will appear.
SET UP & USE