Westinghouse WHC322BA, Руководство пользователя

Страница: 9 / 16

9
INSTALLATION
OPERATION
WARNING
WARNING
To avoid any potential hazard, you must follow our
instructions when you install your appliance. Failure
to install the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
• This appliance must be installed by an authorised
person according to all codes and regulations as
stated in the local municipal building code and other
relevant statutory regulations.
• Wiring connections must be in accordance with AS/
NZS 3000 Wiring Rules and any particular conditions
of the local authority.
• Wiring should be protected against mechanical
failure. Refer to AS/NZS3000 clauses 3.3.2.6, 3.9, 3.10
• A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
• This appliance must be installed by an authorised
person according to all codes and regulations as
stated in the local municipal building code and other
relevant statutory regulations.
• The minimum distances to other appliances and units
are to be observed.
• Turn off the power at the mains before installing
this appliance.
• Supply cords must have a temperature rating not less
than 105°C.
• The surface temperature of the appliance exceeds
95°C. Underbench access must be restricted to
prevent a hazard.
• The clamping joints must be installed by a
qualified electrician.
• The electrical schematic must be observed.
Electrical connection
Before connecting, check that the nominal voltage of the
appliance stated on the rating plate, corresponds to the
available supply voltage. The rating plate is located on the
lower casing of the hob.
The hob is to be connected to the mains using a device
that allows the appliance to be disconnected from the
mains at all poles with a contact opening width of at least
3mm. eg. automatic line protecting cut-out, earth leakage
trips or fuse. A cable with a minimum temperature
rating of V90HT or higher must be used as the mains
connecting cable.
The connection must be carried out as shown in the
diagram. The connecting links should be fitted according
to the appropriate connection diagram. The earth lead is
connected to terminal.
The earth leads must be longer than the leads carrying
the electrical current.
The cable conditions must be in accordance with
regulations and the terminal screws tightened securely.
The connecting cable is to be secured with the mains
cable cleat and the covering closed by pressing firmly
(lock into place).
Before switching on for the first time, any protective
foil or stickers must be removed from the glass
ceramic surface.
TIPS & INFORMATION
IMPORTANT
Once connected to the mains supply, check that all the
cooking zones are ready for use by briefly switching each
on in turn at the maximum setting.
INSTALLING YOUR APPLIANCE