6
TRANSPORTATION & INSTALLATION
If possible avoid placing the appliance near cookers,
radiators or in direct sunlight as this will cause the
compressor to run for long periods. If installed next to a
source of heat or freezer, maintain the following minimum
side clearances:
•
From cookers 100 mm
•
From radiators 300 mm
•
From fridges 100 mm
Make sure that sufficient room is provided around the
appliance to ensure free air circulation. Ideally, a space of
no less than 100mm must be left around the freezer, and
ensure you allow gaps as shown in the diagram below.
100mm min.
100mm min.
100mm min.
Refer to “Cleaning” section on page 8 to prepare your
appliance for use.
If the freezer is installed in unheated areas (garages etc.),
in cold weather condensation may form on the outer
surfaces. This is quite normal and is not a fault. Remove
the condensation by wiping with a dry cloth.
TRANSPORTATION
INSTALLING YOUR NEW APPLIANCE
The appliance should be transported only in a vertical
upright position. The packing as supplied must be intact
during transportation.
WARNING
CAUTION
• Failure to comply with the above instructions could
result in damage occurring to the appliance.
• The manufacturer will not be held responsible if these
instructions are disregarded.
• The appliance must be protected against rain,
moisture and other atmospheric influences.