7 of 8
ISSUED: 02-08-06 SHEET #: 202-9093-1
Mounting and Removing Flat Panel Screen
Hook tilt brackets (
BB
and
CC
) onto wall plate (
AA
).
Then slowly swing screen in as shown. Turn safety/
security screws, using phillips screw driver or security
allen wrench (
FF
), clockwise at least six times to
prevent screen from being removed as shown in detail 1.
of figure 3.1.
Screen can be adjusted horizontally if desired as
shown in figure 3.2.
Note:
To lock the screen down, tighten screws to wall
plate using a phillips head screw driver or securty allen
wrench (
FF
) as shown in detail 1.
To remove screen from mount, loosen screws, swing
screen away from mount, and lift screen off of mount.
3
Unlock tilt position by loosening IncreLok™ tilt
locking screws on both tilt brackets. Adjust
tension knobs shown in detail 2 to desired
tension, balancing your screen size and weight.
Push or pull from top or bottom of screen to
adjust tilt as shown in figure 4.1. The tilt can be
adjusted to a maximum of 15° forward or 5°
backward.
Note
: To lock the screen into the desired tilt
position, use locator hole to find tilt position.
Tighten IncreLok™ tilt locking screws on both
tilt brackets as shown in figure 4.1 and detail 2.
4
Adjusting the Tilt Angle of the Flat Panel Screen
• Be careful not to pinch fingers when pushing screen
from the bottom.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount.
Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
BB and CC
AA
DETAIL 1
AA
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the screen.
WARNING
DETAIL 2
fig 4.1
SAFETY/
SECURITY
SCREW
IncreLok™ TILT
LOCKING
SCREW
LOCATOR
HOLE
TENSION
KNOB
fig 3.1
fig 3.2
