Westinghouse Bottom Mount, Руководство пользователя

Страница: 8 / 20

8
INSTAllATION
(y)
50mm
30mm
30mm
Recommended
airspace
CABINET
DOOR
350mm 550mm for telescopic drawer models
(x)
AdEqUAtE vENtiLAtioN ARoUNd YoUR REfRiGERAtoR.
The diagram below shows the recommended airspace to
allow for ventilation of your refrigerator .
If you don’t have a cupboard with a rear gap, the
recommended clearance area on top increases from 50mm
to 90mm (x) and from 32mm to 72mm (y). When
positioned in a corner area, spacing of at least 350mm
on the hinge side will allow the doors to open enough to
enable the removal of bins and shelves .
Note: For those models with telescopic extension slide-out
bins, the clearance required increases from 350mm to
550mm for top mount and bottom mount models, and to
450mm for the all refrigerator model to allow full access to
the bins’ contents as well as bin removal.
NOTE:
Doors are designed to sit proud of cabinetry (not flush).
The clearances shown above are the recommended
minimum clearances. The clearance at the rear must not
exceed 75mm.
iNStALLiNG YoUR REfRiGERAtoR
Your new refrigerator should arrive with the front adjustable
rollers wound down, to tilt the top backwards by about
10mm from upright . This will allow your refrigerator door to
self-close, providing a consistent closed seal .
The stability foot should also be wound fully up so it will not
interfere with the operation of the rollers (see diagram in
Step 3) .
WARNING
wARNINg
The rollers are designed for forward or backward movement
only . They are not castors . Moving the refrigerator sideways
may damage your floor and the rollers.
iNStALLiNG YoUR NEw AppLiANcE
1. Roll the refrigerator into place.
2 . The top of the refrigerator should be tilted back by
10mm (see diagram on left) . This will allow the doors to
self-close providing a consistent door seal .
3. If the refrigerator isn’t tilted back, you can adjust the
two front rollers by turning the large, plastic roller nut .
(see diagram below) . One turn of the nut increases the
height of the refrigerator by 10mm . If you have difficulty
turning the roller nut, have someone tilt the refrigerator
back, so you have better access . Alternatively, you can
access the rollers from the side, using a flat screwdriver.
(See diagram below) .
4 . Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level . You can
adjust the level with the rollers as detailed in step 3.
5 . If you find your refrigerator rocks from corner to corner,
it means your floor is uneven. Find a piece of plastic or
hardboard etc . and pack it firmly under the roller .
6. On certain floor surfaces the refrigerator may roll
forward during operation. Where provided a “Roller
Stop” can be placed under the front rollers. If Roller
Stop is required, contact customer service on
1300 363 640 .
7 . You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5 .
10mm
Height adjustable
front rollers
Fixed
rear rollers
Large plastic
roller nut
Stability foot
wound up
Top of refrigerator
is level ie. horizontal
Adjust front rollers
for uneveness of floor
eg. wind this roller
down or up
Aligned to
cupboards
ie. even gap
Roller Stop