4. Fit the dampers to the exhaust air outlet. Slight
bending of the dampers will be required for the
fitment.
Fig. 7
5. Hang the body hood on the mounting screws then
secure at the anti-tilt locations(2 places) as indicated
in Fig 8.
Fig.8
Depending on the preferred installation/ducting mode,
follow step 6a or 6b below.
6a. Recirculating mode (Fig.9)
Fix the T-piece to the top mounting bracket by using
the 4 screws supplied as dimension indicated Fig 5.
Adhere two sponge to the outlet of T-piece.
Using the centre line, install the recirculating T-piece
and mounting bracket to the wall.
Install flexible pipe between T- piece and air outlet
Use cable ties or suitable duct tape to secure flexible
pipe to T-piece and outlet of the hood.(Fig.10)
NOTE: When installed in recirculating mode, it is
recommended to use a charcoal filter to prevent odours
being emitted back into the room.
For instructions on fitting charcoal filter, please refer to
page 11 of user manual.
Replacement Charcoal filter part number 09070400082
.
Fig.9
T-piece mounting bracket
Flue cover mounting bracket
Flue cover
mounting
bracket
Fig. 10
T-piece mounting
bracket
6b. Ducted mode (Fig.11)
Insert flexible pipe and secure flue tape to air outlet
with suitable duct tape.
NOTE: For ducted mode we recommended to
extend the flue pipe through the roof cladding(with
appropriate flashing) to an external roof cowl, venting
the exhaust externally.
To ensure optimum performance of the rangehood,
the use of bends should be avoided. Straight, rigid
and short ducting is recommended to use. All ducting
must be fire retardant.