2
4. Carefully remove the factory cross member/hitch from vehicle making sure that all wirings clears.
See Fig. 3.
5. Locate the Hitch Assembly (Item 1) and with assistance align the hitch with the 4 factory threaded holes. Loosely secure
the hitch using the (4) factory bolts. Secure the bumper with the factory bolts.
See Fig. 4.
6. Align and adjust the Hitch Assembly as needed, then fully tighten all hardware at this time. Torque all M14 fasteners to
126 ft-lbs.
Fig. 4
Passenger side shown
Loosely secure the Hitch Assembly with the factory bolts
Secure the bumper
with the factory bolts
CARE INSTRUCTIONS
REGULAR WAXING IS RECOMMENDED. DO NOT USE ANY TYPE OF POLISH OR WAX THAT MAY CONTAIN ABRASIVES.
STAINLESS STEEL PRODUCTS CAN BE CLEANED WITH MILD SOAP AND WATER. STAINLESS STEEL POLISH SHOULD BE USED TO POLISH SMALL SCRATCHES.
GLOSS BLACK FINISHES SHOULD BE CLEANED WITH MILD SOAP AND WATER.
INSTALLATION COMPLETE
Fig. 1
Lower spare tire
Fig. 2
Remove center bracket
Remove (4) bolts
Fig. 3
Remove factory Cross member/ hitch
Remove (4) factory bolts each side
Refer to Fig. 4
