2
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-5854165-RevA
ECO #: W19-0160
DATE: 05/26/20
PROCEDURE
1. Remove contents from box, verify if all parts listed are present and free from damage.
Carefully read and understand all instructions before attempting installation.
Failure to identify damage before installation could lead to a rejection of any claim.
2. Starting at the front mount location, locate (1) Driver Support Bracket (Item 9). Loosely secure brackets, using the supplied
M6 hardware as shown in
Figure 1 and Figure 2.
Driver Side
Front Shown
Outside
Pinch Weld
Figure 1
19
9
Inside Pinch
Weld
Driver Side
Front Shown
Figure 2
9
16
18
17
3. Starting on the drivers side loosely install Rear and Center brackets. Installation is similar to Front Mounting bracket.
Please refer to
Figure 3 and Figure 5 and 6
for bracket orientation and location.
4. Locate (1) Nerf Step Bar and loosely secure it onto the previously installed rear and center brackets using the provided M8
hardware. Partially insert M8 hardware into board and slide the slotted bracket onto the bolt. See
Figure 4.
5. Torque the bolts as far as they can go while still having adjustment.
6. Then locate (1) Front Driver Side Mounting Bracket (Item 3). Loosely secure bracket to vehicle and previously installed
support bracket using the supplied M8 hardware as shown in
Figure 3
.
[
Note:
If a threaded hole is not present use the sup-
plied M8 U-Nut Clip (Item 11)].
Install U-Nut Clip if threaded
hole not present
Driver Side
Front Shown
Figure 3
12
15
12
3
13
14
12
13
15
15
Figure 4
Driver Side
Center Shown
1
5
12
15
15
13 14
Rear Mounting Bracket
Installation Similar
