2
2. Under the hood of the vehicle remove screws and plastic push
-
pins to remove the grille. Once removed carefully pull off
the grille. See
Figures 1 and 2.
PROCEDURE
1. Remove contents from box, verify if all parts listed are present and free from damage.
Carefully read and understand all instructions before attempting installation.
Failure to identify damage before installation could lead to a rejection of any claim.
Figure 1
Remove screws
Figure 2
Remove plastic buttons
Figure 3
Insert (2) M10 bolt plates
into radiator support
Figure 4
Loosely secure straps
onto M10 bolt plates
Figure 5
1
-
3/8 in
4
-
1/2 in
3. Insert (2) M10 bolt plates into the factory holes on the radiator support. See
Figure 3.
4. Locate both straps (Items 4 & 5) and loosely secure to M10 bolt plates using the provided M10 hardware (Items 13
-
15).
See
Figure 4.
5. Cut a hole (4
-
1/2 in. x 1
-
3/8 in.) in both sides of the valance as shown
Figure 5
. And proceed to bracket installation.
6. Locate lower mounting locations for mount brackets (Items 2 & 3). See
Figure 6
.
Figure 6
Factory hardware will be used to
secure mount brackets (Items 2 & 3)
Driver Side Shown
