Westfalia ABH 18, Оригинальное руководство пользователя

Страница: 39 / 62

35
Operation

Do not apply too much pressure if debris blocks the drill hole. Run
the rotary hammer slowly, and remove the bit from the hole. Repeat
until hole is cleared.
IMPORTANT: The following instructions relate to functions of the rotary
hammer only available with the additional purchase of a standard chuck
adaptor or bit holder adapter.
Using a Chuck Adaptor (not included)
1. Insert a standard chuck adaptor into chuck (15).
2. Use rotary drill mode only.
3. Fit drill bit into chuck and tighten securely.
4. Make sure the drill bit runs centrally before use. If not, re-fit bit.
Drilling Wood

Ensure that drill bits are suitable for wood, and are within the
maximum capacity of this rotary hammer (see ‘Technical Data’).
Drilling Metal

To ensure accuracy, mark the intended hole position using a
hammer and centre punch.

Ensure that drill bits are suitable for the grade of metal being drilled,
and are within the maximum capacity of the rotary hammer (see
‘Technical Data’).

To ensure efficient cutting, and prolong drill bit life, use a suitable
lubricant or cutting fluid.
Screwdriver Use
1. Fit a ¼" (6.35 mm) screwdriver bit holder to SDS Plus adaptor into
the Chuck (15).
2. Select gear 1 using the gear switch (4).
3. Rotate the mode selector (2) to drill .
IMPORTANT: This rotary hammer is not optimally configured for
driving screws and should only be used for driving screws
partially into or out of material to speed up operation.