12
NOTE: To attach, align the two tabs on the lance with the recesses in the
pressure cleaner as shown (See Fig. C).
Assembly extension lance
Attach the short lance with multi-spray nozzle to the extension lance (7) (See
Fig. F). Attach the extension lance (7) to the machine (See Fig. E).
NOTE: To attach, align the two tabs on the lance with the recesses in the
pressure cleaner as shown (See Fig. C, E, F).
Attach the hose (8) to the machine.
Connect quick connect coupling (17) to the hose adaptor (5) (See Fig. H1, H2).
NOTE: After attaching the hose, check the connection by gently pulling on the
hose. You should not be able to pull the hose off.
Operation
Select water source
WARNING: Do not use the machine with a water source that is cloudy, muddy
or corrosive.
Suitable water sources:
•
Bucket / water bag
•
Ditches / canals / lakes / sea (After use, the system must be completely
flushed with fresh water).
NOTE: When using in open water (ditches / canals / lakes etc.), make sure that
the filter remains far away from the bottom (move the floater if necessary).
Always use the supplied hose with filter for the water sources.
•
(Drinking) water network. Always in combination with a system
separator. The use of a regulator stop (19) is recommended.
NOTE: Use a standard water hose with suitable coupling (s) for this.
WARNING: Never use the machine without a system separator on the drinking
water network. Ensure that the connection of your water installation to which
the device is connected is equipped with a system separator according to EN
12729 type BA.
WARNING: Water that has flowed through a system separator is considered
non-drinkable.
Switch on / off
To switch the pressure cleaner on, hold down the safety switch (1) and press
the main on / off switch lever (2) (see Fig. B).
Pressure setting
The machine has two pressure settings. The high pressure setting is suitable for
thorough cleaning removal and the low pressure setting is suitable for light
cleaning and watering (See Fig. I). The machine is standard in high pressure
mode. Press pressure setting switch (eco) (3) to activate the low pressure
mode.