Westfalia 87 86 21, Инструкция по эксплуатации

Страница: 12 / 18

8
Operating
Charging the Battery
The build-in battery must be charged before the first use. Store
the unit only in charged state.
Important! Only use the provided power adaptor to charge the
battery.
Connect the charging plug with the charging socket (9) and plug
the power adaptor into the power mains. The control LED (6)
turns green and indicates that the battery is charged. The
screwdriver will not operate during charging.
The LED (6) also indicates the charging state of the battery.
While charging, the battery and the charging station become
lightly warm. After charging process the control LED (6) turns
green to show that the battery is fully charged. Charging process
takes approx. 3 – 5 hours. Unplug the power adaptor from power
mains.
Right / Left Selector
To select the rotating direction, use the right / left selector (5). For
right hand rotation press onto the right hand side of the selector,
for left hand rotation press onto the left hand side.
Turning ON/OFF
The screwdriver will run as long as the main switch (7) is
pressed.
Inserting the Tool Bits
The bits are stored in a cylinder magazine which is stocked by
the factory or may be stored by you as you desire. Push forward
the machine head (4) and turn the cylinder until the desired bit is
at the top, under the window (3). Pull Use the handle (10) to push
the bit into the bit holder. Pull back the macine head. The
Screwdriver is nor ready to use.
To change the cylinder, push the machine head forward and
push out the inserted cylinder to the left. Take the cylinder off the